PARTS LIST :

44 - nuts and bolts
3 - spoke handles

Exterior Panels >
1 - Top panel(#1)
1 - Left Side Panel(#3)
1 - Back Panel(#5)

Interior Panels >
1 - Ceiling panel(#7)
1 - Right Side Panel(#9)
1 - Center Support(#11)
1 - EZ Gunrack(#13)
1 - Side Shelf(#15)
1 - Lower Back Panel(#17)

16 - shelf brackets
1 - Instruction dvd
__________________________

1 - Floor Panel(#2)
1 - Right Side Panel(#4)
1 - Door Panel(#6)
__________________________

1 - Floor panel(#8)
1 - Left Side Panel(#10)
1 - Upper Shelf(#12)
1 - Gun/Side shelf(#14)
1 - Side Shelf(#16)
1 - Upper Back Panel(#18)

Open each of the four boxes and inspect to see if there is any damage and that all parts have been supplied. If anything is missing or damaged please call 1 - 888 - 469 - SAFE(7233)

INTERLOCK-XP
EXTERIOR ASSEMBLY
1. Attach left side panel(#3) to back panel(#5) with bolts provided. Do not tighten bolts at this time.
2. Attach door panel(#6) to left side panel(#3) with bolts provided. Do not tighten bolts at this time.
3. Enter default combination of 1234# and open door
* Be careful at this point as the door could tip over. It is recommended to have a person help you at this point.*
4. Slide floor panel(#2) under lip in front, side and back panel.
Attach with bolts provided. Do not tighten bolts at this time.
5. Attach right side panel(#4) to door, back and floor panel with bolts provided. Do not tighten bolts at this time.
6. Attach top panel(#1) to front, left side, right side and back panels with bolts provided. Do not tighten bolts at this time.
7. Tighten all bolts at this time, aligning each panel while tightening.

INTERIOR ASSEMBLY
8. Insert ceiling panel(#7) with notched side to the front.
9. While holding the ceiling panel in place, insert right side panel(#9). The front edge of the side panel will go into the door frame and be against the stop at the back of the safe.
10. Insert left side panel(#10) The front edge of the side panel will go into the door frame and against the stop at the back of the safe.
11. Insert floor panel(#8) making sure that the panel is all the way forward to the front of the safe, leaving a gap at the back.
12. Insert lower back panel(#17) into the gap behind floor and push all the way back to the stops.
13. Insert upper back panel(#18) into the gap behind ceiling panel and push all the way back to the stops.
14. Install the EZ gun rack(#13) with the brackets provided. Making sure that the EZ rack is at the same height as the seam between the upper and lower back panels.
15. Install upper shelf(#12) at a height that works best for you, using shelf brackets.
16. Install center support(#11) approx. 10 inches from the right side panel with the notch fitting under the EZ gun rack.
17. Install side shelves(#15 and 16) at the desired height with shelf brackets.
18. Place gun/side shelf on top of EZ gun rack on right side.